1.54inch 200x200 E-Ink Display Module
Description：
This is an E-Ink display module, 1.54inch, 200 x 200 resolution, with embedded controller, communicating via SPI interface, supports partial refresh. Due to the advantages like ultra low power consumption, wide viewing angle, great effect under sunlight, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
Features:
No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
SPI interface, for connecting with controller boards like for Raspberry Pi/Arduino/Nucleo, etc.
Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)
Specifications:
Operating voltage: 3.3V
Interface: 3-wire SPI, 4-wire SPI
Outline dimension: 48 x 33mm / 1.89 * 1.30in
Display size: 27.6 x 27.6mm / 10.09 * 10.0*in
Dot pitch: 0.138 x 0.138
Resolution: 200 x 200
Display color: black, white
Grey level: 2
Refresh power: 26.4mW(typ.)
Standby power:<0.017mW
Viewing angle: >170
VCC: 3.3V
GND: Ground
DIN SPI MOSI pin
CLK: SPI SCK pin
CS: SPI chip selection, low active
DC: Data/Command selection (high for data, low for command)
RST : External reset, low active
BUSY: Busy status output, low active
- Comments(0)
You might like
-
-
-
Universal e-Paper Raw Panel Driver Board（ESP32 supports WiFi and Bluetooth）$12.99 or 1560 BeansRedeem Now -
-
-
-
-
-25%
-
-12%
-
-
-
-
-
1.54inch 200x200 E-Ink Display Module
Out of stock
