4 way fast charge module 12V/24V to QC3.0
Module characteristics:
1. Built-in synchronous switch step-down converter chip
2. Input voltage range: 4.5V to 32V (the input voltage must be higher than the output voltage because it is a voltage drop module)
3. Output voltage range: 3V to 12V, automatically adjusted according to the fast charge protocol
4. Output power: 24W (4V@3.6A, 5V@3.4A, 9V@ 2.5A, 12V@2A, etc.)
5. Output voltage cable compensation
6. The output has CV / CC characteristics (output current is less than the set value, output CV mode; output current is greater than the set value, output CC mode)
7. The conversion efficiency reaches 97%
8. Soft start function
9, 220Khz switching frequency
Output fast charge:
1. Support BC1.2, Apple, Samsung agreement
2. Support Qualcomm QC2.0 and QC3.0
3. Support MTK PE1.1/PE2.0
4. Support Huawei fast charge protocol FCP (note that many Huawei mobile phone systems do not support fast charge)
5. Support Samsung Quick Charge Agreement AFC
6. Support Spreadtrum fast charge protocol SFCP
Multiple protection, high reliability
1. Output over-current, input over-voltage, input under-voltage, output short circuit protection
2. Over-temperature protection of the whole machine
Features: each of the four channels supports QC 3.0 fast charge protocol, can support fast charge at the same time, can output 5V 9V 12V (requires mobile phone protocol support) voltage, output current is adaptive, single channel power consumption 24W, 4-channel module power consumption 96W, PCB adopts FR-4 1.6mm board thickness design, optimized layout and wiring, tight design, open window on the back for heat dissipation, low full load working temperature, standby current 0.013A, and the module has an output voltage compensation function.
Note: This module is a 4-way pressure drop fast charging module, please use 12V-30V DC power supply, and the positive and negative poles cannot be reversed.
- Comments(0)
You might like
-
-15%
PCBWay Single-Channel Relay Module with Delayed Power-off, Triggered Delay, and Cyclical Timing Circuit Switch$1.69 or 200 BeansRedeem Now -
-
Four Way Holder V3 Development Board（Compatible with Raspberry Pi/STM32)$8.99 or 1080 BeansRedeem Now -
-50%
1 Channel Relay Module 5V with optocoupler Support High and Low Level Trigger$0.99 or 120 BeansRedeem Now -
Relay Module Interface Boards for Arduino Low Level Trigger 5V 2 Channels$2.00 or 200 BeansRedeem Now -
-
-
LM2596S DC-DC 3A Buck Adjustable Step-down Power Supply Converter Module$0.99 or 120 BeansRedeem Now -
-
-
-
-
USB isolator/USB to USB isolator digital signal audio power isolator ADuM3160$9.99 or 1200 BeansRedeem Now -
-
-
Dual 18650 Battery Holder V3 Development Board（Compatible with Raspberry Pi/STM32)$4.99 or 600 BeansRedeem Now -
18650 Battery Holder V3 Development Board（Compatible with Raspberry Pi/STM32)$3.99 or 480 BeansRedeem Now
4 way fast charge module 12V/24V to QC3.0
Out of stock
