Can-Bus breakout

A small project to add some ease of use to the common MCP1215 Can-bus Module. These modules usually operate only at 5v, making them great for the older Arduino boards, like the UNO, but other newer boards, including the ESP32 or Raspberry Pi, require the use of Logic level converters, The problem arises from the CAN-bus transceiver chip, which is a 5v only device. As there are still quite a lot of these chips in circulation, and with their relatively low cost, I have decided to give is a slight redesign, adding logic conversion, which should enable it to be used with 3v as well as 5v devices. The module also fits on a breadboard, adding another feature. PCBWay once again did a very good job at manufacturing the PCB... Thank you