SmartHome Ethernet controller

The project includes two PCB board: 1. PCB CPU includes: microcontroller ATMega328PU, Ethernet-SPI controller ENC28J60 / SS 3.3V power supply, Two RJ-45 connectors and a transformer POE indication for the inputs and outputs and supply voltages connector for programming. 2 POWER PCB includes: Two relays for switching 220 VAC 6 triacs for 220 VAC three-channel PWM 8 inputs for connecting analog and digital signals 2 additional ADC channel Ethan Supply for POE 5Volt Ethan Supply for POE 5Volt The boards are installed in the company D6MG GAINTA housing for din rail, took place on 6 standard modules. After connecting to the network and the supply voltage, it is possible to control this device via a web browser, or by means of GET POST requests. Configuration and programming is also possible via the ethernet network It is possible to connect simple buttons and switches - Switches, buttons, etc. - Detectors (leak detectors, motion detectors, fire detectors) - Analog sensors to the ports P0-P5 (light sensors, ultraviolet light, gas, etc.) It is possible to connect digital sensors ? Digital temperature sensors DS18B20 - Digital temperature and humidity sensors DHT11 / DHT22 - Readers of keys iButton (TM) DS1990A - Readers of keys Proximity EM-Marine and VIZIT-RF (Dallas protocol support) - 1-wire DS2401 Tags To manage the load you can use the built-in relay 2, and 6 triac optically isolated, including a three-channel PWM dimming. The device can operate under the control of the server operating on Windows / Linux system via POST GET request system The device can operate autonomously on the programmed algorithm, which is stored in the EEPROM.