Guitar Hero Clone Hero Mechanical Strum PCB
Guitar Hero STRUM PCB
YOU WILL NEED
- Pi PICO With header pins
(Some Pico Clones don't share the same pinout) -DOUBLE CHECK
- Kailh Box Switches
- Appropriate USB CABLE
- 24-26 AWG Stranded Wire
- Soldering capabilities
What guitars will this fit?
- Kramer
- SG
- Xplorer
- LP
- WT
- GH5
Extra pictures added to show hole compatibility
How do I program the Pi Pico?
Use Sanjay's "Santroller" software to configure
https://santroller.tangentmc.net/
Some guitars need case modifications to close
You can trim off the plastic pegs where it interferes with some wire cutters
case pegs may interfere with the area where you solder the frets and where the USB cable comes out so don't force it down on first fit
0603 sized SMD component spots added to support USB AUTH Detailed in the Santroller documentation
SMD components may not be needed or you could want to use GP2 and GP3. if that's the case you can use the GP Bridges to bypass the components needed
Little to no support is offered, this PCB has been tested on Kramer, WT, GH5, LP and XP
You can message me on Discord @ Snare01 but don't expect much. I'm just a hobbyist
NOTE: I do not offer ANY support if you have been sold this PCB as a kit or standalone. Contact the original seller for hardware support
Guitar Hero Clone Hero Mechanical Strum PCB
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(3)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Snare 01
-
Terminal Curiosity PCB Ruler
104 0 0 -
(DIY) COMMODORE 64 DEAD-TEST (781220) DIAGNOSTIC CARTRIDGE
213 0 2 -
Creative Micro Designs Inc. CMD FD-2000 / FD-4000 3D Printable Case
301 0 0 -
Creative Micro Designs Inc. CMD FD-2000 / FD-4000 Metal Case
435 0 0 -
-
-
IoT Indoor system with ESP32 to monitor Temperature, Humidity, Pressure, and Air Quality
923 0 3